Doll dresses are fun to make. First of all, however, learning quality is a quality design for the novice rule beginners. To get started, you need to consider the dough. Tailor-made with quality harmonies that some people like multicolored clothes need clothes.
You will need the appropriate equipment and tools to make sure you achieve a quality doll dress. You will need a sewing machine, cleaning agent, universal needle, including stretch needles, pins, olfaa panels, and rotating or pivoting cutters. You will also need hand-stitched needles, sewing scissors, sewing scissors, cloth paste and pen, oil-resistant paper for tracing, pencils, measuring tapes, laces, ribbons, fasteners, elasticity, paper scissors, etc.
Before you begin, you need to clean your sewing machine. Use "dust," to spray your machine near the bobbin area. You also need to clean the bar where the needle is attached and the "tension" disc at the top. Once you have removed the dust machine, use oil drops.
Some of these create these models and are donable models. Make sure that you have forgotten the thread specifically made in France for the purpose of a DMC broder.
How to trim:
You can use the pin tuck method to trim your doll's clothes. You will need feet designed for twin needles, and pinch pins. Set up the machine The right hand should turn clockwise while turning counterclockwise. For a "tension" disc, the left needle must be screwed in on the same side and the right needle must be screwed in the right thread. As a dress, pinch the pins in front of your spray dress in fresh and available starch.
How to Fix Tack Skirt:
It is a space with a way home with a piscat at the time.
How to Pin the Tuck Sleeve and / or Bodice:
Take the square of your fabric and the pins push it in. You can cut out the top of the dress and / or sleeves later. Please let me know the points in case If the sleeve size and the bodice fabric size for pinching the pin are changed or reduced.
If you are not familiar with Pintuck, you can pinch your doll's dress. To squeeze, just consider the size and width of your garment. To start, press and hold the folded center. Stitch the width exactly along the folds and edges of your fabric. As long as you stay consistent within your stitch line, it works fine. After pulling a single thread, you should always start sewing with grain.
After completing your clothes, or near the end, you may want to consider the purpose to be sewn by a bow, tuft, smock, or hand. Hand embroidery is ideal for finishing. Use a range of DMC embroidery to finish your dress.
Finished with smocking is complete for your pattern. Silk ribbons, satin single and double ribbons make up a large pinafore, or back dressing.
Tassels can be made easily, but you need crochet and embroidery threads to complete your mission. You will also need a cardboard that needs to be cut longer than your tufts. Use your thread, wrap around the cut and continue until you achieve the thickness you want. Use the same thread at one end of the part and thread it through the thickness. Next, tie a thread to make it a knot and cut off the opposite end of your piece. Please do not cut your thread. Now you are ready to make your bunch.
To finish, carry your yarn to meet your tassel, in a tied area. Next, wind another piece of yarn several times about the finish of your tufts. Tie the area as it is tight. At the end of your tuft, skid a thread to fasten your finished job. If you need cutting to make sure the finish is constant, go now.
How to make a chime
Did you know that you can take an old reddish-brown clay made of unglazed pottery to make a chime? (Terra cotta pot)
The pot constitutes a nice batch of chimes. You will need up to the ceramic pot to get started. The diameter should be approximately 11⁄2 inch and up to 1⁄4 inch. You need a wood, six plates of 4 inch time and a varnish finish. You will need up to 5/8 inch grommet screws. Add up to ten rounds of beads made of wood and about 3/8 inches of spool, up to 30 anglers' line of pounds. Requires wires up to 20 yardsticks, ie spools and 7/8 inch grommet screws .
How to make a chime:
Now you are ready to make your chime. Add a coat of varnish on a wooden plate, allow it to dry, and continue several times adding varnish as needed. Using your grommet 5/8 screw, screw it into the plate and screw it in by hand. If added, the additional screws keep them inch apart. Cut your line measurement vertically. Next, feed the line at each end and to the grommet screw. Work through the line until you reach the area under the ship.
After completing the steps, run another line of vertical measurement of the wood beads and fix them to form a double bond. If you feel the need to do so, you can use glue to fasten the area.
For the use of other vessels, bells, screws, and longitudinal measurements of regulation. Eyelet 7/8 screw please. Tighten the screw in the center of the crown plate. Please use this wire for this article.
End with your chime now. In order to complete this article you will be able to keep the wind during the cold months and place some snakes under the area under your door to make some snakes
If you do not have a cloth garden around your home, buy a cloth or a corduroy strong textile garden. You need a yarn to adjust with your dough. In addition, stuffing, dried beans and rice are required. Add some glue and felt, preferably red, white, black.
Then collect your dough and trim it up to 10 inches wide and approximately 6 inches tall. Measure your door before cutting so you will need a length greater than the bottom area of your door. Use two parts of the outer area of your fabric, collect and hand or machine away at least three sides and about 3/8 inches away from the end of your fabric It is necessary to leave the area. Hide your seams on the right side of your fabric and add your filling, ie packing. There is also a rim, which is a design snake that designs selected additives.
If you choose to do so, you can use glue, buttons, studs, etc. to make your eyes. Similarly, you can use your felt to supplement the mouth, nose, etc. Using red felt to make lips, tongue etc., black is like a lid, or eyebrow, so to compensate for the surrounding features about the eyes.
The snake also makes a great warming gift. I will be a friend to customers who can craft number. A warm winter near a few houses.
0 comments:
Post a Comment